Specification
2062R Receiver
- Measurement Category: CAT IV 600V
- Operating Voltage: 600V AC/DC
- Operating frequency:
Energised: 6.25kHz De-energised: 32.768kHz
- Signal indications: Numeric bar graph display and audible beep
- Response time:
Smart Sensor 500ms Tip sensor (energised/De-energised): 500ms NCV: 500ms Battery monitoring:5s
- Range detection (open air):
Smart Sensor Direction Indication Mode: ≤15 cm (6 in), 230 V AC, high mode, sensitivity level 2 Tip Sensor: Energised: Max distance via air: Up to 6.1m (20ft)/Pinpointing approx: 5cm (1.97in) Tip sensor: De-energised: Max distance via air: Up to 4.5m (14.7ft)/ Pinpointing: approx 5cm (1.97in) NCV (40Hz to 400Hz): Max sensitivity: 90V up to 2m? Min sensitivity: 600V to to 1cm
Display
- Display size: LCD 89mm (3.5in)
- Display dimensions (W x H): 70mm x 52mm (2.76 x 2.07in)
- Display Resolution: 480 x 320 pixels
- Display Type: Colour TFT LCD
- Display Colour: 16-bit
- Backlight: Yes
Environmental
- Operating temperature: -20ºC to 50ºC (-4ºF to 122ºF)
- Operating humidity:
45%: -20 °C to <10 °C or 40 °C to 50 °C (-4 °F to <50 °F or 104 °F to 122 °F) 95% (non-condensing): 10 °C to <30 °C (50 °F to 86 °F) 75%: 30 °C to <40 °C (86 °F to <104 °F)
- Operating altitude: 2000m (6581ft)
- Pollution degree: 2
- IP rating: IP40
- Drop test: 1m (3.28ft)
Mechanical
- Power supply: 4 x AA batteries
- Power consumption (Typical): 110mA
- Battery life: Approx 20 hours
- Low battery indication: Yes
- Dimensions (L x W x H): 277 x 112 x65mm (10.92 x 4.43 x 2.55in)
- Weight: Approx 0.544KG (1.2lb)
2000T Transmitter
- Measurement Category: CAT IV 600V
- Operating Voltage: 600V AC/DC
- Operating frequency:
Energised: 6.25kHz De-energised: 32.768kHz
- Signal indications: LEDs and audible beep
- Response time:
Line Voltage: 1s NCV: 500ms Battery monitoring:5s
- Current output of signal (typical):
Energised circuit: High mode: 60 mA rms/ Low mod: 30mA rms De-energised circuit: High mode: 110mA rms/Low mode: 40 mA rms/ Loop mode with test leads: 160mA rms/Loop mode with i400 AC current Clamp: 385mA rms
- Signal voltage output (nominal):
Energised circuit: High mode: 14W @ 230V ac/50 Hz, 3.33kΩ @ 230 V ac/ Low mode: 4.6 W @ 230 V ac/50 Hz, 11.5 kΩ @ 230 V ac De-energised circuit: High mode: 31 V RMS, 140 Vp-p, 0.86 W @ 1 kΩ load Low mode: 27.5 V RMS, 120 Vp-p, 0.1 W @ 1 kΩ load Loop mode with test leads: 32 V RMS, 140 Vp-p, 0.87 W @ 1 kΩ load Loop mode with i400 AC Current Clamp: 31 mV, 0.89 W @ 1 Ω load
- Range detection (open air):
Tip Sensor: Energised: Max distance via air: Up to 6.1m (20ft)/Pinpointing approx: 5cm (1.97in) Tip sensor: De-energised: Max distance via air: Up to 4.5m (14.7ft)/ Pinpointing: approx 5cm (1.97in) NCV (40Hz to 400Hz): Max sensitivity: 90V up to 2m? Min sensitivity: 600V to to 1cm
Display
- Display size: LEDs
- Display Type: LEDs
- Display Colour:
Operating Mode LEDs: red Battery Status LEDs: green, yellow, red
Environmental
- Operating temperature: -20ºC to 50ºC (-4ºF to 122ºF)
- Operating humidity:
45%: -20 °C to <10 °C or 40 °C to 50 °C (-4 °F to <50 °F or 104 °F to 122 °F) 95% (non-condensing): 10 °C to <30 °C (50 °F to 86 °F) 75%: 30 °C to <40 °C (86 °F to <104 °F)
- Operating altitude: 2000m (6581ft)
- Pollution degree: 2
- IP rating: IP40
- Drop test: 1m (3.28ft)
Mechanical
- Power supply: 8 x AA batteries
- Power consumption (Typical):
High/Low mode: 70mA Loop mode with clamp: 90mA Consumption without signal transmission: 10mA
- Battery life:
High/Low mode: approx 25hrs Loop mode: Approx 18hrs
- Fuse: 1.6A, 700V fast acting, Ø 6 x 32 mm, 50 kA interrupt
- Low battery indication: Yes
- Dimensions (L x W x H): 183 x 93 x50mm (7.2 x 3.66 x 1.97in)
- Weight: Approx 0.57KG (1.25lb)
i400AC Current Clamp
- Measurement Category: CAT IV 600V/ CAT III 1000V
- Operating Voltage: 1000V AC
- Current Range: 400A
- Basic accuracy: 2 % + 0.06 A (45 Hz to 400 Hz)
Environmental
- Operating temperature: -20ºC to 50ºC (-4ºF to 122ºF)
- Operating humidity:
10 °C to <30 °C (95 %: 50 °F to <86 °F) 30 °C to <40 °C (75 %: 86 °F to <104 °F) 40 °C to <50 °C (45 %: 104 °F to <122 °F)
- Operating altitude: 2000m (6581ft)
- Pollution degree: 2
- IP rating: IP40
- Drop test: 1m (3.28ft)
Mechanical
- Maximum conductor size: 32mm 91.26mm (1.26in)
- Dimensions (L x W x H): 150 x 70 x30mm (5.9 x 2.75 x 1.18in)
- Weight: Approx 0.114KG (0.25lb)
2000ACC Test Lead Accessory Kit
- Includes:
2 x 1m test leads (red,black) 1 x 7m test lead (green) 2 x test probes (black) 2 x alligator clips (red, black) 2 x outlet blade adaptors 2 x outlet
- Measurement category:
CAT IV 600V (test leads), CAT II 1000V, CAT IV 600V (alligator clips) CAT II 300V (outlet adaptors)
- Operatomg voltage and current:
600V 10A max (red/black leads), 600V 10A max (green lead), 1000V 8A max (black probe) 600V 10A max (alligator clips), 300V 10A max (outlet adaptors)
- Operating temperature: 0°C to 50°C (32°F to 122°F)
- Operating humidity:
0°C to <30°C (95%: 50°F to <86°F), 30°C to <40°C (75%: 86°F to <104°F) 40 °C to <50 °C (45 %: 104 °F to <122 °F)
- Storage temperature and humidity: 0°C to 60°C (32°F to 140°F)
- Operating altitude: 2000m (6561ft)
- Pollution degree: 2
- Water and dust resistance: IP20
- Drop proof: 1m (3.28ft)
- Dimensions: Red/black leads: 1m (3.28ft), Green lead: 7m (22.97ft), Alligator clips: approx. 95 x 45 x 24mm (3.74 x 1.77 x 0.94in), Outlet adapters: 72 x 18 x 18mm (2.83 x 0.71 x 0.71in)
- Weight: Approx 0.4KG (0.88lb)
|